Testing my Drafted Pattern

I’ve made my drafted pattern, but I want to check how it will fit before I sew up a bra.

Testing

There are a couple of ways I can test the fit before I start sewing up a whole bra. In Beverly’s Craftsy class, Foam, Lace & Beyond, she shows how to convert your Classic pattern from a diagonal seam to a horizontal seam. I did this to compare the two patterns because the original pattern I made from the draft was a horizontal seam.

It’s looking pretty good on paper and I’m feeling encouraged.

Alterations

Even though I’m encouraged by my pattern, I still want to make a tester cup. There are no alterations done to this basic pattern, and I have a list I usually need: make the underarm smaller, a flat spot adjustment, check the bridge height and bottom width. Then there are the Omega considerations. Making a test cup is simply one more confirmation for me.

This tester cup is looking good too.

Here’s the dart I pinched out. I’ll adjust the pattern and then it’s time to cut out a new bra! I’m going to adjust the strap and upper cup at the side too. You can see both in the photo below.

A Trial Bra

My sewing was going along nice and smoothly, and then a tiny snag. I pulled the elastic out of the finding kit and it was the ‘old’ elastic. There’s been a change in elastics and the newer one is 20% less stretchy. It’s a good thing the Fairy Bra Mother blogs. I went over to Beverly’s blog and used her information to take out that extra width I’d added to my band. You can read her post here.

I not only looked that up, but also her post on sewing a Gothic Arch because it’s such a comfortable alteration.

New Bra

Here’s my new bra. It fits so well, and I’m so excited about it! I think I’m more excited about this bra than any bra I’ve made in the past.

Here’s the side view. You can see there are a couple of little alterations I want to make.

The pin there? I want to take a little more out from the underarm there. As well, I’ll want to raise the side there 1/4-inch. The wire is coming to the top of the elastic, that’s why I didn’t finish it there.

The back is fine. Taking out that 20% makes it fit perfectly.

Here’s the Gothic arch I added. It is such a comfortable pattern alteration.

All in all, I’m thrilled with my new bra, and the drafting experience.

Happy creating!

P.S. You may want to look at A Review of Sewing Bras: Foam, Lace & Beyond.

Print Friendly, PDF & Email

4 thoughts on “Testing my Drafted Pattern

  1. I am going to try a partial band and gothic arch next. Gosh, bra making is addictive.

Comments are closed.