I was so close on that last bra. And at this point, I do have a drawer full of bras I can wear that mostly fit. But I must admit, I am like a dog with a bone when I want to figuring something out – and getting that perfect fit is my objective.

I’d recently read something very encouraging from Annele, the founder of MakeBra said:

“An older lady, who was running her own lingerie business only few years ago, told me that you need at least twenty test fitting sessions before the bra pattern is ready to go.”

You can read about it here. Oh, that was such a relief to read. Then I’m not obsessed, or a terrible sewer. Whew!

Thankfully, at one time I’d bought the same Fantasie bra, but one size bigger. I think it was one size bigger. For example, what would be the size difference between a 34D and a 34DD? The only charts I have are from Bra Makers Supply, and they don’t do the double letters.

Back to the bra. I’d cloned it, and then after wearing it for a little while, gave it to a friend because I found it a bit loose in the upper cup. However, I was thinking this size would be perfect  with the firmer Duoplex material. All the materials are from Bra Makers Supply.

Here it is. I think it shows the cups are a little fuller than the last bra. And just because the cups are fuller, it doesn’t show here how the bridge is really narrow at the top. The channeling and wires completely overlap at the top of the bridge. And the bridge goes all the way back!

As much as I loved the thin ribbon on the original Fantasie Vivienne, I couldn’t find anything in a beige or tan, only white. So I went with some bows I had for this bra.

Here is a picture from the inside to show the wires and channeling overlapping at the top. It’s a bit tricky to sew this. What I do is sew the first channel down completely, and then the second channel is only sew down completely at the top and on the inside seam.

On the outside seam where the channeling pieces are overlapping, I do not sew it completely. There’s only maybe 2 cm opening where it is not sewn on the outside of the channeling. It has to be left open on the outside there so the wire can slide through that lower channeling.

On the top piece of channeling, I sew up to the outer seam line on the lower channeling, and it makes an attractive inverted V-shape in the stitching on the front of the bridge.

And here is the back. I reduced this to make it a 2 hooks and eyes set again. This is how the original RTW bra came, so I wanted to do that again. It’s a wonderfully comfortable bra – and the bridge goes all the way back except for a tiny bit at the very top after I’ve been wearing it for a bit. It looks like I’ll be shortening my wires by 1/4″. But at least I’ll still have a full bridge.

Now I have a pattern that really works for me, the next thing I want to do is to take this pattern and use it to figure out what size I’d want to make in all my other patterns – the Sewy Rebecca, and the Pin-Up Girls Shelley and Classic, and the Merckwaerdigh E-BHST2 and E-CUPL 16.

And now I have one more pattern in my collection to try – Norma from Orange Lingerie just released a bra pattern! The Marlborough bra pattern. You can find the pattern at Orange Lingerie’s Etsy shop.

Happy creating!