Oh, some very good news. Draft number four fit so well I couldn’t resist making a new bra. For the most part, my cups were fine. I’d done a lot of work on those. The wires and the bottom of the bridge were what needed the most improvement. So, now I had a well-fitting band, with the correct wire shape, I had to make a new bra.
I looked in my stash, and this lovely delicate lace was calling my name.Oh, I love this lace. It’s so pretty.
My next decision was what to use to finish the bra? I decided to try the lingerie satin B,Wear sells. I had ordered some, but hadn’t tried it yet. I think I fell in love with it as soon as I touched it. It’s so soft!
This lingerie satin does have a bit of stretch, so I wasn’t sure how my bra was going to fit, but I am not disappointed.This is the BMS Ruby pattern, adjusted for an Omega shape.
This fits perfectly – except I forgot to adjust the top of the bridge to make it lower. This bridge is for using elastic along the upper edge, so the bridge and the wires aren’t the same length. However, that’s a very small complaint!You can see here where the wires aren’t coming to the top of the bridge. There’s maybe 2 cm, or better yet 1.5 cm and a touch of wiggle room for the wires. It’s a very small adjustment after some of the others I’ve had to make.
You can also see in the above photo, I had some wrinkling with my elastic under the cup there. I had this problem on my other tester band too. I’m wondering if I have too much of a curved shape there making it just too hard for the elastic to fit to those curves.
Here’s the side view of the bra.Oh, I’m so happy with this. I used a trick I learned in one of my classes with Jeannette to help my large cup fit into my smaller band – I stretched the frame on the outside, and ‘eased’ the cup in. It works so well.
Lastly the back view. I’m so thrilled to have finally found my correct sized wire, and figured out just how to fix my band as well. I have my next bra kit all picked out, and I’m going to sew some more bras!This is another lingerie satin kit from B,Wear.
I do like a power bar, so I’m thinking for my next bra I’ll make a BMS Shelley.
Happy creating!