Last week I shared my Sure Fit Designs sloper. It was too big, the bust dart was too low. Seeing as both my friend and I were both dealing with the same issues, I put it down to user error. It was our first attempt, so I could only get better.

So I started over. I measured everything again, and my bust and waist measurements were a bit smaller this week.

 I redrew the whole pattern, and cut it out and it’s fitting much better.

There are still a couple of changes I plan to make. My bust measurement came out to a half number, and I think I’ll round up for my next one rather than use the half.

And of course lengthen it to hit my waist.  

As well, that waist dart is coming up too high. The lengthening will fix that.

Still, this is much better than the first attempt.

Happy creating!