The Flexible Wire Experiment

I did a little bra-wearing experiment. I still wasn’t 100% happy with my fit. Do you get the idea I’m looking for perfection? I am!

At the end of the day, I could see when I undressed, the wires I was using weren’t fitting me perfectly. I also knew from experience that a size smaller felt like it pinched a bit. So, if the size I’m wearing is too big, and one size smaller is too small, where did that leave me?

I’d read something recently about the flexible wires available at Bravo Bella, Needle Nook Fabrics, and Sew Sassy. I decided to give them a try and see if they’d solve my wire problem. I ordered three sizes from Needle Nook Fabrics – 36, 38, and 40. Anne St. Clair was so very helpful. I must say, women like Anne and Beverly Johnson are a tremendous help to us non-professional bra-makers. Thank you!

I could tell with just a glance that the 40 wires were the same size I’d been using, so I ruled them out, initially. The 36s felt perfect but were too short for me to use. That left the 38s. I popped out the Vertical wires I’d been using from my most recent Black Butterfly bra and wore the flexible wires for a day. (Here’s a confession: I didn’t even sew the seams up!)

Here are the two 38 wires  – one regular and one flexible:

100_2951

And this second photo shows just how much these flexible wires can flex:

100_2952

That’s tremendous. There’s no way a regular wire is going to move like that! As well, the flexible wires don’t splay outward anymore than the regular wires I’d been using did – I checked. They flex inward.

Just before I popped those new wires in, I pressed them together to make the curve a little narrower. On the Bravo Bella web site, Monica Bravo has a couple of videos about the wires, and on one she explains how they can be shaped. That sounded perfect to me.

At the end of the experimental day, I could see these wires were a much better fit for me. Yay! I now have a nice little stash of flexible wires on their way to me.

Now to adjust my pattern to help with the wire fit. I’ve learned though, change one part of the bra pattern, and it means changing something else. Now I decided to look at the cradle those wires are fitting into. What I’ve been using is drawn from a 38 wire cradle that I lengthened to fit the 40 Vertical wire. I wanted to change that. Clearly, the channel that fit a 38 wire was too big.

In this photo, you can see the bridge and then the 36 and 38 cradle lines. There’s not a lot of difference between the cradle sizes, but I think one size will be just enough to make things a little more comfortable and fit better. The main problem with a cradle that’s too big is the weight of the breasts will push the bra frame down and you won’t get the support you need. The cradle really needs to fit.

I traced the 30E on this pattern (the smallest cradle size on it). I’d been using the 32E cradle for my last few bras. I’d even tried the 34E cradle, which would normally take  a 40 wire, so I would have fewer cup alterations, but I found it really didn’t help with my fitting issues – just my alteration ones.

100_2955

So, out came my pencil, eraser, and medical exam table paper. I traced of the 30E cradle and then laid my custom pattern pieces over that to add those aspects to the pattern – the narrower and lower bridge, adjusting for a flat spot, thinning out the elastic under the bust, and raising up the side 1/4″.

At this point all the alterations were good to go. In fact, you’ve seen them! I used them all on my last bra – the Sewyfied Shelley. That bra is my best-fitting bra! There are only a couple of cosmetic changes I want to make at this point. What a great feeling that is!

Happy creating!